The A component is A flowing liquid (that is, silica gel), and B is the curing agent. Die first kind of handle or copy products, take a certain amount of colloid, add 2-3% of curing agent, joined at room temperature curing agent 2%, 3%, 30 minutes to operation, the silica gel after curing agent mix of pumping air into vacuum state, then finished bubble of silica gel to be within the direct injection mould. 2-4 hours mold can be solidified. Translucent mould silica gel for liquid liquid, general product after curing, hardness range + / - 2 a °. If the customer needs to make a large product, such as split the mold, the mold with the high hardness of the mold silicon will be used; Instead, complex patterns and subtle and small molds, such as mold, must be made with soft mold silicone. The amount of the curing agent can be determined according to the actual requirements of the customer, and it is required to dry quickly and remove the molds quickly, and the curing agent should be added accordingly. On the contrary, if you need to slow down a little bit, add a little bit of hardener (but no more than 5% of the curing agent should be added).
Is mainly used for gypsum craft gift industry, mold manufacturing, glass crafts, simulation plants and animals sculpture, Buddha carving crafts, furniture decoration industry, character copy, artificial culture stone, culture stone villa, cement plaster, large products, such as Roman column rolling over.
