Operation method of mould silicone:
1. After a certain amount of the base glue is taken, the curing agent is mixed with the curing agent by 2 to 4 percent of the material.
2. The solidifying agent will be added to the adhesive, the glue will be put into the vacuum box for 4-6 minutes, the vacuum time should not be too long, and the exhaust bubble will be able to mold.
3. Put the silica gel to besmear to brush or vacuum casting way down in the products above, besmear brushs wants even, 30 minutes to stick a layer of gauze to increase the strength of the silicone and tension, then brush a layer of silicone operation on this method, a general 2 times, so out of the silicone mold service life and the number of rolling over relatively improve a lot, and can improve the efficiency and cost savings.
4. The vulcanization speed of this product is closely related with ambient temperature and humidity. The higher the temperature, the higher the humidity and the faster the vulcanization speed. The user can select the curing agent according to the weather condition and adjust the dosage of the curing agent to obtain the proper curing rate.
