The mold silicone must have good operating performance.
Silica gel has better liquidity and low viscosity.
The smaller the silica gel, the better.
The pull of silica gel is better.
The silicone molds that are made are not deformed.
The hardness of silica gel should be suitable for product use.
With the melting point of the candle, it does not take the oil, easy to release the mold, the more times, the longer the service life, the acid and alkali resistance to aging.
1. Before using large quantities, please take a small trial and master the technique of using products so as to avoid mistakes.
2. According to the manufacturer's instructions, the ratio of the ratio is accurate. Please remember that the ratio is weight ratio rather than volume ratio. After the mixing of AB glue, it needs to be fully mixed to avoid unsolidification or imperfection.
3. If the curing time can be accelerated after the initial solidification of liquid silica gel, it will heat up immediately after cutting, which will cause the curing agent to evaporate and become unsolidified.
4, in the same direction when AB mixed stirring, pour glue with higher at the same position on the master pattern a little bit of fall, let glue on the master pattern natural flow, this can increase the flow of the gel time and reduce the bubbles.
5. For the sake of remoing, the mold can be sprayed on the mother die.
